SEHT120404 CBN Insert for Cast Iron, 1/2″ Square

Cubic Boron Nitride Turning, Milling & Fly-Cutting Insert, Cuts up to 70 HRC, Fits SEHT Holders

Machine what carbide can’t. This SEHT120404 insert uses a CBN (cubic boron nitride) tip. CBN ranks second in hardness only to diamond. It cuts hardened steel up to 70 HRC, cast iron, and superalloys.

• Cuts Cast Iron to 70 HRC: CBN machines hard, abrasive materials that regular carbide can’t touch.
• Holds its edge red-hot: It stays sharp at extreme temperatures. Run higher speeds and faster cycles without burning up the tool.
• Can replace grinding: The fine surface finish and size control let CBN replace many grinding steps. Two operations become one.
• Far longer tool life: It wears far slower than carbide in hard material. You change tools less and lower your cost-per-part.
• For ferrous only: Use it on hardened steel, cast iron, and superalloys. For aluminum and non-ferrous metals, use the PCD version.
• Specs & fit: 1/2″ square (12 mm), 0.19″ thick, 0.2″ bore, 0.4 mm corner radius (04). Fits standard SEHT holders, face mills, and fly cutters.
• Sold as 1pc or 10pc value packs.